News

  • Downstream application market drives mold development

    Downstream application market drives mold development

    According to different application fields, mold products can be divided into automotive molds, IT molds, home appliance molds, OA equipment molds, medical equipment molds and metal molds. Among them, automobile molds are known as "the mother of the automobile industry", because more than 90% of the ... read more

    Oct 19,2019 Industry News
  • What is the cause of silver line marks in plastic mold products

    What is the cause of silver line marks in plastic mold products

    Silver line marks refer to the appearance of long needle-like white, frost-like fine lines on the exterior of the product. These fine lines often form a “V” shape with the tip facing away from the gate. As shown in the following figure, the common way of silver line marks is The acicular silver-whit... read more

    Oct 26,2019 Industry News
  • Analysis of plastic mold industry problems and development suggestions

    Analysis of plastic mold industry problems and development suggestions

    Core Tip: As one of the pillar industries of China's light industry, the plastics industry has maintained a growth rate of more than 10% in recent years. In the plastics industry, the plastics hardware market is very active, becoming a new consumer hotspot and a new economic growth point. The plasti... read more

    Nov 01,2019 Industry News
  • What is the plastic mold consisting of?

    What is the plastic mold consisting of?

    Mold injection molding is a processing method used in batch production of complex parts of certain shapes. The detailed principle refers to: the plastic raw material that is heated and ablated is pushed by the screw of the injection molding machine into the cavity of the plastic mold, and after cool... read more

    Nov 09,2019 Industry News
  • What issues should be paid attention to in the design of plastic molds?

    What issues should be paid attention to in the design of plastic molds?

    The problems that should be paid attention to in the design of plastic molds are as follows: 1. The rubber inlet should be opened in the thick part of the product to ensure that the filling is smooth and complete; 2. Although it is opened at the margin or bottom without affecting the appearance and ... read more

    Nov 15,2019 Industry News